Radicore Forum: Workflow » WorkFlow Engine

Home » RADICORE development » Workflow » WorkFlow Engine

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

WorkFlow Engine [message #385]

Thu, 09 November 2006 02:22

ijulius
Messages: 1
Registered: November 2006

Junior Member

Guys,

I have tried WorkFlow System on radicore. I have entry data on workflow process, workflow place, Workflow Transitions, and Workflow Arcs. But I don't understand when
Workflow Cases, Workflow Tokens, and Workflow Workitems will show
data when I search data on list each module.
How to use workflow system?

Report message to a moderator

Re: WorkFlow Engine [message #389 is a reply to message #385]

Thu, 09 November 2006 05:21

AJM
Messages: 2382
Registered: April 2006
Location: Surrey, UK

Senior Member

When you create a workflow you must also define the places, arcs and transitions which are to be used in that workflow. The workflow record also identifies the STARTING_TASK, which means that this particular workflow will not be used to create a workflow case until that task is actually run. The creation of a workflow case will then cause the creation of tokens and work items in order to show the current state of that case.

The workflow database should be pre-loaded with 5 examples which are triggered by the 'Add Person' task. You can test any one of these by removing its END_DATE (note: you must set the END_DATE of all the others in the past so that only one of these workflows is active at any one time).

If you look in file radicore/workflow/docs/workflow-examples.html you will see a description on these 5 examples.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

Previous Topic:	time splits and workitems
Next Topic:	Trigger Message to send e-mail

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 04 17:37:00 EDT 2025

Total time taken to generate the page: 0.09903 seconds