Radicore Forum: How To » Calling List2 from a List2

Home » RADICORE » How To » Calling List2 from a List2

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Calling List2 from a List2 [message #2369 is a reply to message #2368]

Mon, 16 November 2009 04:39

AJM
Messages: 2398
Registered: April 2006
Location: Surrey, UK

Senior Member

When you select occurrences of 'DevicePort' and press a navigation button the framework will extract the primary key from every selected row and place it in the $where string which is passed to the next object. If the primary key of the 'DevicePort' table is 'device_id+port_id' then both values should be included.

If 'port_id' is being excluded then it is one of the following:
(1) It is not defined as part of the primary key, therefore is not being extracted into the $where string.
(2) It is being extracted, but somehow it is being filtered out.

If it is #2 then you will have to step through the code with your debugger so see where it is happening.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:25
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 04:39
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:45
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 07:24
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 20:04
		Re: Calling List2 from a List2 By: AJM on Tue, 17 November 2009 04:15

Previous Topic:	Use a blank controller
Next Topic:	Multiple Checkbox Control

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 14 08:51:21 EST 2026

Total time taken to generate the page: 0.01392 seconds