Radicore Forum: How To » Calling List2 from a List2

Home » RADICORE » How To » Calling List2 from a List2

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Calling List2 from a List2 [message #2370 is a reply to message #2369]

Mon, 16 November 2009 04:45

ljkbrost
Messages: 59
Registered: April 2006

Member

So based on my table layout would you say my primary key is:

1) port_id
2) device_id, port_id

I ask because #1 above gives me the same problem and #2 allows it work. I was thinking that device_id is a foreign key.

Thanks.

Report message to a moderator

[Message index]

		Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:25
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 04:39
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:45
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 07:24
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 20:04
		Re: Calling List2 from a List2 By: AJM on Tue, 17 November 2009 04:15

Previous Topic:	Use a blank controller
Next Topic:	Multiple Checkbox Control

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 14 18:06:44 EST 2026

Total time taken to generate the page: 0.03808 seconds