Radicore Forum: Framework » User configuration in a VPD

Home » RADICORE development » Framework » User configuration in a VPD

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: User configuration in a VPD [message #7916 is a reply to message #7915]

Mon, 14 April 2025 14:31

htManager
Messages: 456
Registered: May 2014

Senior Member

Yes, I am aware of the implementation of VPD and it works very well.
But as far as I can see, the mnu_role table does not have a rdcaccount_id column and surely this shows all available roles?
However, I would like only two roles to be selectable when a new user is created by an “account admin”. Is that possible?

Report message to a moderator

[Message index]

		User configuration in a VPD By: htManager on Fri, 11 April 2025 06:49
		Re: User configuration in a VPD By: AJM on Sat, 12 April 2025 04:42
		Re: User configuration in a VPD By: htManager on Mon, 14 April 2025 14:31
		Re: User configuration in a VPD By: AJM on Tue, 15 April 2025 04:49
		Re: User configuration in a VPD By: htManager on Tue, 15 April 2025 17:51
		Re: User configuration in a VPD By: AJM on Wed, 16 April 2025 05:03
		Re: User configuration in a VPD By: htManager on Wed, 16 April 2025 17:37
		Re: User configuration in a VPD By: AJM on Thu, 17 April 2025 04:39

Previous Topic:	PDF - drawing with lines
Next Topic:	Introduction to the Radicore framework

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jun 12 23:11:14 EDT 2026

Total time taken to generate the page: 0.00670 seconds