Radicore Forum: RADICORE Installation Issues » 'Build Directory' is not working!

Home » RADICORE » RADICORE Installation Issues » 'Build Directory' is not working!

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: 'Build Directory' is not working! [message #1073 is a reply to message #1072]

Thu, 30 August 2007 09:13

AJM
Messages: 2397
Registered: April 2006
Location: Surrey, UK

Senior Member

All the database table classes in Radicore are actually subclasses of std.table.class.inc which contains all the method names which are called from the page controller.

_cm_post_getData() is called from the superclass(std.table.class.inc) immediately after the getData() method.

If you did as I asked and stepped through the code with your debugger instead of simply looking at the code you would see the path taken through the code, and you would see where it was failing.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		'Build Directory' is not working! By: bbkwon on Wed, 29 August 2007 17:06
		Re: 'Build Directory' is not working! By: AJM on Wed, 29 August 2007 18:03
		Re: 'Build Directory' is not working! By: bbkwon on Wed, 29 August 2007 18:49
		Re: 'Build Directory' is not working! By: AJM on Wed, 29 August 2007 19:40
		Re: 'Build Directory' is not working! By: bbkwon on Wed, 29 August 2007 20:58
		Re: 'Build Directory' is not working! By: AJM on Thu, 30 August 2007 04:38
		Re: 'Build Directory' is not working! By: bbkwon on Thu, 30 August 2007 08:49
		Re: 'Build Directory' is not working! By: AJM on Thu, 30 August 2007 09:13
		Re: 'Build Directory' is not working! By: bbkwon on Thu, 30 August 2007 17:34
		Re: 'Build Directory' is not working! By: AJM on Thu, 30 August 2007 18:28
		Re: 'Build Directory' is not working! By: bbkwon on Thu, 30 August 2007 22:07
		Re: 'Build Directory' is not working! By: AJM on Fri, 31 August 2007 05:17
		Re: 'Build Directory' is not working! By: bbkwon on Sun, 02 September 2007 09:59

Previous Topic:	Problem with _cm_formatData in v1.27, Detail view
Next Topic:	Existing data do not show up in LIST2

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Nov 10 21:38:03 EST 2026

Total time taken to generate the page: 0.01013 seconds