Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.
Home » RADICORE development » Framework » Output 5 (Label view)
Re: Output 5 (Label view) [message #7578 is a reply to message #7577] Tue, 23 February 2021 16:01 Go to previous messageGo to previous message
htManager is currently offline  htManager
Messages: 459
Registered: May 2014
Senior Member
Yes, that is all right what you say. In my Paradox application (PC based) I can print all tickets between start_no and end_no by generating the quantity of tickets with code in a method. And my approach was that I could do the same in Radicore.

I think that I expressed myself wrong. I store the start_no and the end_no in one record. At the moment this is the (one and only) record which is printed. Everything is correct!

What I am searching for is a (the) place/method where I can store the code best to increase the table with all the records from start_no til end_no (e. g. 400 tickets from number 1 til 400). After the table has the right quantity of records the $object->getData_serial($where) will be working with all these (expanded) records. I hope that I could express myself a little bit better/clearer now.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Key value / special characters /add4
Next Topic: Location of new (Sub-) System
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Aug 14 19:11:00 EDT 2026

Total time taken to generate the page: 0.01025 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.2.1.
Copyright ©2001-2025 FUDforum Bulletin Board Software